shadow.enabled in housecarl.yaml loads Housecarl's ruleset so that it
blocks, rejects and translates nothing: drops and rejects count and
accept (an accept only ends Housecarl's chain), policies accept and log
what they would drop, NAT only counts, MSS clamping and the flowtable
are left out, and raw rules that do more than accept, drop or reject are
left out with a warning. Comments mark what would happen ([would drop]).
Filter chains run after the other firewall's (+10) or before (-10); NAT
chains always first. Every change is checked by nftables in both forms.
No probation; takeovers and closing connections are refused. The boot
fallback filters nothing. internal/tablewatch puts the table back after
a flush ruleset. Mode in status, healthz, whoami, the web UI, the log
and the tracer; hc ruleset --enforcing. docs/shadow.md.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
The boot unit fails closed: if ruleset.nft doesn't load, it loads
ruleset-fallback.nft (render.Fallback), saved beside it from the same
configuration: nothing new in from external zones, established, the
ICMPv6 IPv6 needs and DHCPv6 replies let in, the inside left alone and
masqueraded, and the unit marked failed with a critical message.
housecarld replaces it when it applies; status, the dashboard and
/healthz say while it is in force. no_external_zone now also says the
fallback closes everything without an external zone.
The boot ruleset has no flowtable: nftables on Debian 13's kernel
refuses one naming a device that doesn't exist yet (ppp0 before PPPoE),
and with it the whole file. internal/linkwatch listens to rtnetlink link
messages; housecarld applies again when a flowtable device appears or
comes back as a new interface (by ifindex), under the engine's lock.
docs/flowtable.md: what it does, when to use it and when not, how.
GET /healthz reports firewall (applied, unconfigured, fallback,
missing), changes on probation and the machine's warnings, with 503
unless in force, read at most every five seconds.
Renaming a zone, set or service changes what names it in the same
change (one history entry, one undo); dynamic sets keep their names.
The importer keeps a chain's head in order: once a would-be built-in
stays a rule, the ones after it do too, so the maintainer's ICMPv6
accepts stay behind the invalid drop as written. hc settings set
--flowtable none empties the list.
make test (nft 1.1.3) and make e2e (242 checks, with VLAN
sub-interfaces, the fallback and the flowtable) pass.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
abrown38andClaude Opus 5.5