housecarl/docs/validation.md

Validation

Every change is checked as a whole configuration before it is applied. An error stops the change; a warning is reported with it, and stays on the dashboard and in hc status until fixed. Each problem has a stable code, shown by the CLI as [code] and in the API as problems[].code. housecarld check runs the checks on the saved configuration.

After Housecarl's own checks, nftables checks the rendered ruleset (nft -c). What it refuses (mostly raw rules) comes back as a firewall error with nftables' message, and nothing is changed.

The warnings marked host compare the configuration with this machine's interfaces.

Names

Zones, sets, services and port forwards have names (a forward's is optional): a letter, then letters, digits, - and _, up to 48. Names are unique per kind, ignoring case.

Code		When
zone_name, set_name, service_name, forward_name	error	not a valid name, or one that looks like an address
zone_name_taken, set_name_taken, service_name_taken, forward_name_taken	error	another object of the kind has that name

Settings

Code		When
policy	error	a policy that isn't accept or drop
settings_address	error	an own prefix or antispoof entry that isn't an address or prefix, or is in the wrong list (an IPv6 prefix in the IPv4 list)
flowtable_device	error	a flowtable device with a wildcard: name each device
flowtable_device_missing	warning, host	a flowtable device doesn't exist; the flowtable is left out until it does
probation_range	error	the probation isn't 10 to 3600 seconds

Zones

Code		When
zone_empty	error	no interfaces
zone_interface	error	not an interface name (up to 15 characters; a trailing * matches many)
zone_interface_taken	error	the interface is in another zone already
zone_interface_missing	warning, host	the interface doesn't exist here (yet); its rules match once it does
no_external_zone	warning	no zone is external: antispoofing, MSS clamping, the DHCPv6 client rule and port forwards without public addresses need one

Sets and services

Code		When
set_entry	error	an entry that isn't an address, prefix (without host bits) or range
set_empty	warning	a set (not dynamic) with no entries: rules using it match nothing
set_dynamic_entries	error	configured entries on a dynamic set: its entries come at run time
set_timeout	error	a timeout on a set that isn't dynamic, or under a second
service_empty	error	a service with no entries
service_entry	error	an entry that isn't PROTO/PORTS (tcp, udp, sctp; a port or range) or icmp/TYPE, icmpv6/TYPE with a type nftables knows

Matches

These apply to rules, source NAT and redirects.

Code		When
unknown_zone	error	a zone that doesn't exist
match_in_zone	error	in zones on the output chain (it has no incoming interface)
match_out_zone	error	out zones on the input or early chain, or on a redirect
match_address	error	an address that can't be read
unknown_set	error	a name that is neither an address nor a set
unknown_service	error	a service that is neither built in nor yours
family	error	a family that isn't ipv4 or ipv6
match_never	error	the addresses, services and family can't all match the same packet (IPv4 sources and an icmpv6 service)

Rules

Code		When
rule_chain	error	a chain that isn't input, forward, output or early
rule_action	error	an action that isn't accept, drop, reject or log
raw_rule	error	a raw rule over several lines, or with ;
raw_conflict	error	a raw rule with other fields set (zones, addresses, services, limits, log…): it is used as written, so they would be ignored
early_conntrack	error	connection states, limits or a connection limit in the early chain, which runs before connection tracking
early_reject	error	reject in the early chain: drop instead
ct_state, ct_status	error	an unknown connection state or status
rule_day, rule_hours	error	an unknown day, or hours that aren't HH:MM, or only one of them
rule_limit	error	a rate that isn't a number per second, minute, hour or day
rule_conn_limit	error	a connection limit under 1
rule_limit_unit	error	a rate's unit that isn't packets, bytes, kbytes or mbytes
rule_limit_bytes	error	a byte rate nftables can't hold: over 4 GB a second, 293 MB a minute, 4.9 MB an hour or 208 KB a day (the message gives it per second)
rule_limit_key	error	a limit both per source and per destination
rule_quota	error	a quota under 1 byte
rule_quota_key	error	a quota both per source and per destination
rule_quota_reset	error	a reset that isn't daily, weekly or monthly; a day with another reset than monthly; a day outside 1-31
rule_group	error	a grouping prefix outside 1-32 (IPv4) or 1-128 (IPv6)
rule_traffic_accept	error	a rule with a quota or a byte rate that accepts: it is checked before established connections are accepted, so it can only drop, reject or log
rule_every_packet_accept	error	a rule checked against every packet (every_packet) that accepts: it comes before established connections are accepted, so it can only drop, reject or log
flowtable_traffic	warning	a forward rule checked against every packet (a quota, a byte rate, every_packet) while the flowtable is on: it only sees each connection's first packets
reject_with	error	tcp-reset on a rule that matches more than TCP, or with an action other than reject
log_prefix	error	a log prefix over 100 characters

Port forwards

Code		When
forward_protocol	error	no protocols, or one that isn't tcp, udp or sctp
forward_ports	error	the public port isn't a port or range
forward_to_port	error	the inside port isn't one port, or is given for a range of public ports
forward_target	error	neither to nor to6, or to that isn't one IPv4 address, or to6 one IPv6 address
forward_public	error	no public addresses and no external zone, or an IPv6 public address
forward_overlap	error	another forward has the same protocol, port and public address
forward_hairpin	warning	hairpin without public addresses: inside clients' connections can't be recognised

Source NAT and redirects

Code		When
snat_to	error	to isn't one address, or of another family than the rule (give the rule the family)
snat_everything	warning	no out zones and no sources: everything leaving the firewall is translated
redirect_service	error	no service, or one without TCP, UDP or SCTP ports
redirect_to_port	error	the local port isn't one port

The machine

These come from housecarld looking at the machine, not at the configuration: the dashboard and hc status show them.

Code		When
nftables_service	warning, host	Debian's nftables.service is enabled: at boot it loads /etc/nftables.conf, and stopping or restarting it runs nft flush ruleset, deleting Housecarl's table too. Disable it with systemctl disable nftables (without --now)
takeover_pending	warning, host	the table you imported from is still in force beside Housecarl's, so a packet must get past both; hc takeover TABLE deletes it once Housecarl's rules are right